one.A connecting link of an O-ring Chain for common application is pre-coated with grease at the pins. Just before connection, confirm the grease over the surfaces of pins, and in case the volume of grease is compact, apply grease with bare hands. (If gloves are applied, the grease will be absorbed from the gloves.)
Instance: Once the connecting website link (I) of an O-ring chain for general application is
shipped, O-rings are fitted in the roots of the pins. If your O-rings come loose as a consequence of vibration for the duration of transport, refit the O-rings in on the roots of the pins.
In this case, be sure to return the grease collected on the roots on the pins for the central surfaces on the pins, far more at portion A than at portions B shown within the above illustration. (Portions A is worn as a consequence of sliding using the bushings.)
2.The chain could be most simply linked within the teeth of the sprocket. Engage the hyperlinks at both ends with the chain with all the sprocket teeth and fit connecting pins. Should the sprocket is often moved, the chain can also be linked over the loosened side.
three. Connecting process
1.Confirm that O-rings are connected to the roots from the pins.
two.When the level of grease applied within the connecting pins is compact, coat the pins with grease on the central portions.
three.Insert the connecting pins in to the bushings with the inner back links at both ends.
four.Confirm that the grease is applied towards the whole encounter of the O-ring, and fit the O-ring onto the connecting pins.
5.Insert the connecting pins in to the connecting plate and although pressing the connecting plate, set up the spring clip. Confirm no matter whether the head (the end without a split) from the spring clip is turned in the feeding route of your chain. (See the next illustration.)
six.You should definitely verify the spring clip is securely fitted from the clip grooves from the connecting pins.
This completes jointing on the connecting hyperlink. Note that grease to the surfaces of connecting pins and O-rings is usually eliminated through installation operate. In this case, re-grease using the grease to the surface with the base chain or the grease from the polyethylene bag through which the connecting link was contained.